Zilog ZUSBOPTS - Manual (Page 15)

UM025503-0814 Setup and Operation
Zilog Educational Platform
User Manual
9
2. Connect the USB (A to Mini-B) cable to your PC and to the J5 console connector on
the Platform.
If the Windows OS displays a Driver Not Found message, you must install a USB driver.
A standard USB driver is resident on the Flash drive that you received with your Kit, but a
driver can also be downloaded from the FTDI website at
http://www.ftdichip.com/Drivers/
VCP.htm
3. Connect the 9 V power adapter to the J1 jack or insert the 9V battery; set the Power
Selection switch accordingly.
Figure 6. Key Pins Trim Plug
Note: