Zilog Z80380 - Manual (Page 32)

Compiling and Downloading Introduction
1–20 UM004001-COR1103
D OWNLOADING A COMPILED FILE
Perform the following steps to load the a HEX file.
N OTE : A terminal program (PC host communication software) is required for initialization,
communication, and testing. The following steps are shown using the Hyper terminal program pro-
vided with Windows.
Open the Terminal
Perform the following steps to open the terminal:
1. Power-up the PC.
2. Launch a terminal program, Hyper Terminal is included with Windows.
3. Open the configuration screen of your terminal program, see Figure 1-11.
F IGURE 1-11. S ETTINGS FOR HYPER TERMINAL MONITOR
4. Select the COM port number where the evaluation board is connected.
5. Set the data rate at 9, 600 bps .
6. Set the bits to 8 bits with no parity.
7. Select no flow control.
8. Click OK.
9. Press the reset button on the board. This returns a command prompt and the board is ready
to communicate with host PC.