Adtec digital DTA-3050 (version 6.02.14) Manual User Manual
Page 20
Administrator Mode
Important: As of Release v.5, all Adtec DTA3050 units are shipped with auto log-out time set to "None". The unit can be
configured by any user without going through a log-in procedure.
To set up an auto-time out:
Step
Action
1
Press the <Up> arrow twice, until the panel reads "Auto Logout Time".
2
Press <Select> until the cursor appears on the word "NONE".
3
Use the <left> and <right arrows> to select a time from 1-9 (minutes).
4
Press <Enter>.
5
<Escape> takes you back to the "Status" menu.
Logging In: If you must log back in after being timed out, you must log into the unit from the front panel as an administrative
user. The default front panel login password is "USER".
To log in, press the following key sequence:
Step
Action
1
Press UP arrow
2
Press SELECT
3
Press ENTER
4
Press RIGHT arrow
5
Press ENTER
Once logged into the unit as an administrative user, the entire suite of configuration possibilities is unlocked for use. Note that
changes made in Administrator Mode are not permanent until a "save all" command is executed or until the menu times out
and returns to Status mode.
17
Getting Started