Adtec digital DTA-3050 (version 6.02.14) Manual - Manual (Page 88)

Output re-multiplexing:
The DTA provides full multiplexing and re-multiplexing capabilities including:
PCR re-stamping •
Jitter on ASI and GIGE less than 80 nS •
PID remapping •
PID collision detection and re-mapping •
Transport Stream and Service ID renumeration •
Service ID renaming •
Full Table (MPEG, DVB, ATSC) support •
Any Table type in to any table type out •
Concurrent DVB and ATSC table support in development •
Ghost (virtual service) creation •
ASI Output
ASI egress up to 210 Mbs
Any input service(s), SPTS or MPTS can be re-multiplexed into the single SPTS or MPTS ASI output. ♦
•
Tables per DTA ASI output
One PAT, CAT ♦
•
A PMT per service •
Format Tables Allowed
DVB
1. One SDT
2. Lists all services routed to ASI
3. One NIT
a. List RF Parameters
b. Lists all services routed to ASI
4. One EIT
a. Provides event information data (viewer guide)
b. Pass and/or Local generation
One TDT/TOT
ATSC
1. One MGT
a. xVCT
2. One STT
3. One RRT
4. Four (minimum) EITs (One for each 3 hour block)
a. Up to 128 EITs (16 days) are supported per ATSC A65/B
b. Pass and/or Local generation
5. Four(minimum) ETTs (One for each EIT)
a. Up to 128 ETTs (16 days) are supported per ATSC A65/B
b. Pass and or Local generation
77 Appendix