Desa MSRBVN - Manual (Page 5)

5 106706
OWNER’S MANUAL
For more information, visit www.desatech.com
STOVE BODY ASSEMBLY
1. Lift off corrugated box enclosing stove
body crating.
2. Remove all screws fastening the wood
frame enclosure. Spread wood frame open
and lift away from plastic-bagged stove
body. The bottom pieces of pallet wood
will remain bolted to the stove body.
3. Remove plastic bag from stove body.
4. Remove back panel from stove and dis-
card (see Figure 6). Use an adjustable
wrench or a 10 mm socket. Remove six
(6) bolts and washers. Keep bolts and
washers to attach rear cover.
5. Remove all contents from inside stove
cavity. Contents include:
(1) - Stove bottom (Discard - Not used
with this application)
(4) - Legs with leg leveler bolts
(1) - Bottom door
(3) - Top grates
(1) - Hardware kit bag with fasteners
6. Carefully lay stove body on back to at-
tach bottom components to stove body
(see Figure 7). Rest stove on drop cloth
or blanket to avoid scratching stove edges.
7. Remove remaining pallet wood at-
tached to bottom of stove body (see
Figure 8). Use an adjustable wrench to
remove bolts.
8. Fasten each leg to stove with four (4)
M8 x 1.25 - 20mm bolts. Use a flat
washer and lock washer with each bolt.
Tighten bolts into threaded holes on
stove body (see Figure 9 and Figure 10,
page 6). Use an adjustable wrench or a
12mm socket.
Figure 7 - Laying Down Stove On Side
Figure 6 - Removing Back Panel
CAST IRON STOVE
AND B-VENT
BURNER SYSTEM
ASSEMBLY
Continued
Bolt
Product
Identification
Label
Back
Stove
Panel
Pallet
Wood
Bolted to
Bottom of
Stove Body
Front of
Stove Unit
Top of Stove Unit
Front of Stove Unit
Stove
Unit Drop
Cloth/
Blanket
Figure 8 - Removing Pallet Wood From The Bottom of The Stove
Pallet Wood
Bolt Pallet Wood
Bottom Of
Stove Unit
Front
Figure 9 - Locating Threaded Holes for Legs and Door Attachment
Door Hinge
Step Bolt Hole
Door Catch Bolt With
Adjustable Hex Nuts Hole
Leg
Hole
Leg Hole
Leg
Hole
Front
Bottom Of
Stove Unit