Anthony Gallo Strada - Manual (Page 12)

Therefore, we recommend that you wait until the break-in period is over and you have
determined the optimal location and position for each speaker before permanently
attaching your speakers to a wall.
If you have questions concerning the placement or positioning of your Stradas, either
contact your Anthony Gallo Acoustics dealer, contact us by phone at
(800) 459-4183, or contact us by e-mail at [email protected].
Connecting Your Stradas
Before connecting your loudspeakers to your home theater receiver or amplifier, be sure to
turn off the receiver or amplifier and unplug it from the power outlet.
Caution: Failure to turn off the receiver or amplifier and unplug it from the power
outlet before connecting your Stradas may cause damage to your home theater
system.
Using two-conductor, 18-gauge, solid-core, oxygen-free wire, connect the positive (red)
and negative terminals of each speaker to the corresponding positive (+) and negative (-)
terminals on your receiver or amplifier.
9
Additional Items Required for Installation
The following additional items are required when installing your Stradas and connecting
them to your home theater system:
Item Description
Mounting Hardware A floor mount, table stand, or a wall mount can
be used for mounting your Stradas. These can
be obtained from your Anthony Gallo Acoustics
dealer.
Connecting Wire Two-conductor, 18-gauge, solid-core, oxygen-
free wire should be used to connect Stradas
to your home theater system. This wire is
optional and can be obtained from Anthony
Gallo Acoustics.
Adjustable Wrench A small adjustable wrench should be used to
tighten the speaker connections.
Mounting Your Stradas
Your Stradas can be used with a floor stand , a table stand , or a wall mount (Figure 5).
Separate instructions are provided for assembling the mounting hardware and attaching it
to the rear of your Stradas.
Note: If you purchased a floor stand, table stand, or a wall mount for your Strada,
these will each be packaged in a sparate carton. Installations for assembling and
installing these items are included in their carton.
When you initially install your Stradas, you will likely change the location and/or position
of one or more of the speakers before you find that the speaker locations and positions
are optimal for the particular size, geometry, and construction of your home theater and
the listening area. Also, the speakers require a break-in period of approximately 50 hours
to develop their full sound potential.
8
Figure 5. Strada Mounting Alternatives
Floor
Stand
Wall
Mount
Table
Stand