Anthony Gallo Strada - Manual (Page 15)

Warranty Information
You must fill out and return the warranty card or register your warranty on our web site:
https://www.roundsound.com/registration.php This will establish your ownership and
activate the warranty of your Reference Strada loudspeakers.
When you enter the warranty information, you will need the serial number of each Strada.
The serial number is located on the rear of the speakers.
The Stradas come with a five-year parts and labor warranty. The warranty is valid for the
original purchaser only and cannot be transferred to subsequent users of this product.
Statement of Warranty: Anthony Gallo Acoustics Limited Warranty
Anthony Gallo Acoustics products must be purchased through an Authorized Dealer or
Distributor to receive warranty service. If you purchased your product from an On-line
Auction, Internet Reseller, un-authorized Dealer or Distributor, your product(s) warranty is
void and you will not receive any service or repair.
We warrant this product to be free from defects in materials and workmanship for the
specified terms stated above. Antony Gallo Acoustics will, at its option, repair or replace
this product or any defective parts. An original invoice must be retained and the product
registered with Anthony Gallo Acoustics to establish ownership.
This warranty will be void if:
1. Any defect in this product is the result of abuse, misuse, damage in transit, defective
associated equipment, faulty installation, the use of the unit with equipment for which it
was not intended, or acts of God.
2. The unit has been operated contrary to instructions contained in this Owners Manual.
3. The unit has been serviced by unauthorized personnel.
11
Important: Be sure that each positive (red) connector on your Stradas is connnected
to the corresponding positive (+) speaker output connector on your home theater
receiver or amplifier receiver. If the positive (red) and negative connectors on one of
your speakers are inadvertently switched, that speaker will be out of phase with the
other speakers and the sound will be muffled.
Setting Speaker Controls at the Receiver or Amplifier
After you have connected your Stradas, set the controls for those speakers on the receiver
or amplifier as outlined below:
Control Setting
Speaker Size Small or Normal
Crossover Frequency 80 to 120 Hz on stands
40 to 80 Hz wall mounted
Note: Always follow the instruction manual for your audio visual receiver when
setting speaker controls.
10
Figure 6. Loudspeaker Connections
Positive (Red)
Negative