Appendix b: panel mounting and vesa mounting – Aplex Technology ARCDIS-108 User Manual
Page 54
ARCDIS-1XX (TB-6028) User Manual
53
Appendix B: Panel Mounting and VESA Mounting
The ARCDIS-1XX is designed to be panel-mounted and VESA mounted as shown in
Picture. Just carefully place the unit through the hole and tighten the given screws
from the rear to secure the mounting.
Figure B: Panel mounting and VESA mounting
*
Notice：
Tighten the mounting clip screws by hand until the gasket seal contacts
the mounting surface uniformly.
Tighten the mounting clips screws to a torque of 8 ~ 10 kgf-cm by using
the specified sequence, making sure not to overtighten.
*Tighten the mounting clips to the specified torque to provide a proper
seal and to prevent damage to the product. Aplex assumes no
responsibility for water or chemical damage to the product or other
equipment within the enclosure due to improper installation.