Artesyn ATCA-7368 Installation and Use (June 2014) - Manual (Page 52)

Hardware Preparation and Installation
ATCA-7368 Installation and Use (6806800M12D) 52
Removal Procedure
To remove a USB flash module, proceed as follows:
1. Remove blade from system as described in Removing the Blade on page 56 .
2. Remove the screw on the left side of the flash module.
3. Lift the flash module from the socket.
Installation Procedure
To install a USB flash module, proceed as follows:
1. Remove blade from system as described in Removing the Blade on page 56 .
2. Insert new flash module in socket.
3. Tighten the screw on the left side of the flash module.
2.6 Installing and Removing the Blade
The blade is fully compatible to the AdvancedTCA standard and is designed to be used in
AdvancedTCA shelves.