Artesyn NITX-300-ET-DVI Installation and Use (August 2014) - Manual (Page 87)

BIOS
NITX-300-ET-DVI Installation and Use (6806800N97B) 87
5.5.2.8 OEM-reserved Status Code Ranges
5.6 Boot Order Support
The boot firmware shall be capable of booting an image from eUSB flash, MicroSD and SATA-
attached hard disk.
0x05 System is entering S5 sleep state
0x10 System is waking up from the S1 sleep state
0x20 System is waking up from the S2 sleep state
0x30 System is waking up from the S3 sleep state
0x40 System is waking up from the S4 sleep state
0xAC System has transitioned into ACPI mode. Interrupt controller is
in PIC mode.
0xAA System has transitioned into ACPI mode. Interrupt controller is
in APIC
Table 5-30 ASL Status Codes (continued)
Status Code Description
Table 5-31 OEM-reserved Status Code Ranges
Status Code Description
0x5 OEM SEC initialization before microcode loading
0xA OEM SEC initialization after microcode loading
0x1D - 0x2A OEM pre-memory initialization codes
0x3F - 0x4E OEM PEI post memory initialization codes
0x80 - 0x8F OEM DXE initialization codes
0xC0 - 0xCF OEM BDS initialization codes