Auto-Zone Control Systems Remote Link II Technical Guide, Installation Instructions for the Remote Link II Modem (Version 01C) - Manual (Page 3)

Remote Link II Technical Guide
3
Operator Interface
Remote Link II Overview
The OE419-06 Remote Link II is a modem used for alarm call-
outs and/or to provide for remote communications with your
control system. A second Remote Link II is required at the remote
computer when remote communication with the job site is de-
sired.
The Remote Link II connects to the CommLink communications
interface at the control system location via a nine-pin serial cable.
A telephone line connects the Remote Link to the local phone
service. Using another Remote Link II connected to a computer
and phone service at a remote location, you can monitor and
control the system using Prism software. Connection is made by
dialing the telephone number of the job site where the Remote
Link II is located.
NOTE: WattMaster will not support any other internal or
external modems by other manufacturers.
System Requirements
To enable the Remote Link II to work with Prism, you will need
the following:
• Remote Link II package which includes modem,
9 VDC power supply, 6 ft. long USB cable, 7 ft. long
phone cable, serial cable, and installation instructions
• Conventional phone service (POTS), not attached to
a PBX
• CommLink IV with power adapter and USB cable
• USB drivers on CD-ROM (supplied)
• PC with available USB 1.1 or 2.0 port or serial port
(supplied by others)
• Microsoft ® Windows ® XP, Vista, or 7
(must be installed on the PC you are going to use)
• Prism or Prism II software (can be downloaded from
any of our websites)
General Information
1.50
7.00 5.25
REAR VIEW
FRONT VIEW
MODEM
RS-232
POWER
9 VDC @ 500Ma
COMPUTER
USB
Serial
#
C O N T R O L S
SIG
DET
RDY
SND
REC
PWR
Remote
Link
II
TELCO
LINE
www
.wattmaster
.com
Figure 1: Front and Rear View of Remote Link II
Revised 1/24/11