Auto-Zone Control Systems Remote Link II Technical Guide, Installation Instructions for the Remote Link II Modem (Version 01C) - Manual (Page 8)

Remote Link II Technical Guide
8 Operator Interface
Disabling the Analog Modem Driver Installation
Disabling The Analog Modem Driver
Installation in Windows
®
XP
1. After the USB Drivers have been loaded, the message
“Found New Hardware for Analog Modem” will pop
up from the toolbar. Click on this message.
2. The Found New Hardware Wizard Window will
appear. Click <Cancel> to cancel out of the
hardware installation process.
3. A new message will pop up from the toolbar that
states, “A problem occurred during hardware
installation. Your new hardware might not work
properly.”
4. You now need to access the Device Manager. Left-
click on <Start> , click <Control Panel> , and
double-click the <System> icon. Click the <Hard-
ware> tab and then click the <Device Manager>
button. The Device Manager Window will pop up.
Click on “Other Devices.”
5. There will be a question mark and exclamation point
in front of Analog Modem. Right-click on Analog
Modem and select Disable.
6. A message will appear that states, “Disabling this
device will cause it to stop functioning. Do you really
want to disable it?” Click
<Yes> .
7. The question mark in front of Analog Modem will
now have a red X on it.
8. Continue with the next section “Finding What
COM Port Number the Remote Link II is Using”
on page 9.