Specifications, Heating specifications, Dimensions – Avalon Firestyles Astoria 2001 to 2002 User Manual

Page 7: Electrical specifications, Fuel, Epa compliance

Advertising
background image

Specifications

5

Travis Industries

4 0 1 1 0 0 9

9 3 5 0 8 1 2 6

Heating Specifications:

Approximate Maximum Heating Capacity (in square feet)* .................................800 to 2,250 Sq. Feet

Burn Rate (Pounds per Hour)**.......................................................................1.7 to 5.5

Maximum Burn Time on Low Burn** ................................................................67.5 Hours

Hopper Capacity ............................................................................................115 Pounds

*

Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside
temperature. It is also affected by the fuel size, quality, and moisture level.

* *

Small pellets will increase or decrease the stated burn rates and burn times. Differences of plus or minus 20%
depending on fuel quality may occur.

Dimensions:

Weight: 250 Lbs.

Air Inlet

(1-3/4"

Outside

Diameter)

4"

Diameter

Exhaust

10-1/2”

17-5/8"

1/2"

7-1/4"

Center
Line

33-3/8"

26-1/2"

28"

This keyhole is for

the door handle.

This tab is for

the scraper

rod tool.

Electrical Specifications:

Electrical Rating .......................................................................................115 Volts, 3.6 Amps, 60 Hz

Watts During Start-Up Sequence..............................................................400 (approximately)

Watts During Operation ............................................................................180 (approximately)

Fuel:

The unit is designed for wood pellets that comply with the standards set by the Association of Pellet
Fuel Industry (density of at least 40 lbs. per cubic foot, 1/4" to 5/16" diameter, length no greater than
1–1/2", 8200 BTU's/lb., moisture under 8% by weight, ash under 1% by weight, and salt under 300
parts per million). If the fuel does not comply to this standard, the unit may not operate as designed.

EPA Compliance:

This heater has been tested exempt from EPA Phase II Requirements by OMNI Test Labs.

Advertising