Avalon Firestyles GreenStart Igniter 2 for Freestanding Stoves - Manual (Page 23)

GreenStart Igniter 2 for Freestanding Stoves
Installation Instructions
(SKU 94400951)
Page 23 of 27 17601769.docx — 12/11/13 © Travis Industries, Inc.
Endeavor Installation, continued
14. Attach the igniter cover box to the rear of the stove using the screws removed in step 2.
NOTE: For early Endeavor models, drilling an additional hole is required.
NOTE: The right side flange is tucked underneath the heat shield.
15. Insert the 2 cable holders into the 2 holes on the bottom of the stove. Route the start switch wire under
the stove, through the cable holders.
16. Push any excess start switch wiring into the compressor assembly.
NOTE: A lock-tie is included to secure excess wiring.