Avery Dennison Monarch 9906 Operator Handbook - Manual (Page 30)

S e t t i n g t h e S u p p l y T y p e
You can print on inside edge aperture, black mark, die cut, or continuous supplies. You
have to tell the printer which supplies you are using. To access this setting, from the
Main Menu, select Setup, Supply, then follow these steps.
1.
Press  or  until you see Supply Type.
CHANGE BACK
SUPPLY
Supply Type →
Die Cut
2. Press CHANGE to highlight the supply type options. The current setting is shown.
3. Press  or  to scroll through the supply type options.
SET CANCEL
← Die Cut →
Supply Type
SUPPLY
4. When you see the supply type you need, press SET to save the change. Press
CANCEL
to leave the supply type unchanged.
5. Press BACK until you return to the Home/Online screen.
Supply Type →
Die Cut
CHANGE BACK
SUPPLY
4-2 Operator's Handbook