Avery Dennison 9840 Technical Reference Manual - Manual (Page 151)

MonarchNet for NDS 7-33
Problem: Solution:
Gleaning is used to assign IP
addresses and you "ping" the
Monarch device and the Status LED
remains flashing orange. The glean is not working. Check the
following possible problems:
♦ Verify the ARP table contains the
correct hardware and IP address
by running the "arp -a" command.
♦ If you are getting a response, but
the device LED is still blinking
green, power down the print
server and try the "ping" again.
There might be a different device
answering to the "ping".
♦ Verify the device is on the same
subnet as the computer running
the ping.
The "glean" will not work if the device
has already defaulted to an IP
address 2 minutes after power up.
The Monarch device prints a
configuration label reporting a "No
RARP or BootP" error. If your network does not support
TCP/IP, use an MonarchNet utility to
disable the TCP/IP protocol.
O p e n i n g a n O b j e c t D i a l o g
Options for opening an object's dialog:
♦ Double-click on the object (leaf objects only).
♦ Double-clicking on a container object displays the objects it holds.
♦ Right-click the mouse on the object and select Details from the menu that
appears.
♦ Single-click the object and choose Details from the Object menu.
♦ When creating a new object in the Create dialog, select Define Additional
Properties
♦ and choose Create.