Aviosys 9258S - Manual (Page 11)

IP POWER 9258 USER MANUAL
- 10 -
6. Hardware Control & Settings
* This function teaches you how to use the hardware control the power on/off of the devices
NOTE:
This function is solely used for manually selecting which ports you need to be on or off. It was
designed so that you can still have the ability to turn on or off certain ports in the case you do not
have Ethernet connection.
Before using the H/W control function, please UNPLUG all the 4 connection or ports
connected to the 9258.
Control panel as follow:
To activate Hardware control: Hold the On/Off Button for 5 seconds until you hear one beep
which activates the H/W Control function. The LED lights in the front panel should continuously
flash and you can hear the relay clicking when activated.
To deactivate Hardware control: Hold the On/Off Button for 5 seconds until you hear one beep
which deactivates the H/W Control function.
1. Left Button (Circle button): Select power outlet 1 ~4.
2. Right Button (ON/ OFF): Turn ON/OFF each outlet.
HARD RESET
To Reset the Device Back to Manufacturer Default:
a) First Turn off the device wait for 5 seconds , Press and hold the two buttons on the front
panel of the 9258 at the same time. , then power on the 9258
b) Keep holding until you here 2 short “beep” sounds and one long “beep” sound.
c) Once the device has been reset refer to the following settings below.
Factory default settings:
User Name: admin. Password: 12345678
Device IP Address: 192.168.10.100. Default Gateway: 192.168.10.1