Axel AX4000 User's Manual User Manual

Page 63

Advertising

Downloading

Firmware

AXEL Office Server

b) The Office Server accesses the tftp host via a router

net:hn:df=/etc/btdump:ht=ethernet:sa=192.1.1.243:to=auto:

net1:tc=net:sm=255.255.255.000:gw=192.168.1.252:

axel1:tc=net1:ht=ethernet:vm=rfc1048:ha=00A034100001:ip=192.168.1.242:bf=
/usr/axel/firm9801:

IMPORTANT: if a problem occurred during a previous download operation
(whatever method was used), the firmware of the target Office Server may have
been erased. To restore valid firmware, the bootp+tftp protocol will
automatically be run when this target Office Server is turned on.

5.3.1 - By a rsh Command

The rsh command syntax is as follows:

# rsh axname ax_download file tftpIP routeIP <CR>

- axname: Office Server hostname listed in /etc/hosts,

- ax_download: command option for firmware downloading,

For example:

# rsh ax4011 ax_download <CR>

The following error message can be displayed (on the operator’s console):

- ERR 105: invalid rcmd command: incorrect command option

(check the syntax).

Note: other error messages can also be displayed (connection time-out, for
example). For explanations refer to your system manuals.

5.3.2 - From the Interactive Set-Up

Use a serial terminal or a telnet connection to access the interactive set-up
(cf. chapter 2.1). Select [Download Firmware]