Baby Lock Ovation (BLES8) Instruction and Reference Guide - Manual (Page 34)

The rolled edge setting is used to achieve the narrowest stitch possible (1.5mm) on your Baby Lock
serger. The stitch is suitable for seaming sheer and lightweight fabrics and for edging and hemming
lightweight fabrics.
O
V
E
R
L
O
C
K
S
T
I
T
C
H
E
S
E
X
P
R
E
S
S
32
Rolled Edging
3-Thread Rolled Edge
With the stitch selector set on "D", a narrow hem can become a rolled edge. The fabric edge rolls
around the stitch finger. The upper looper wraps the fabric edge while the lower looper thread is
nearly invisible on the back side of the stitch formation.
Remove the 0-1 needle and thread. Clear the stitch fingers. Turn the stitch length adjusting dial
clockwise into the rolled hem range and set the dial at 1.5. (fig. A) Set the stitch width dial to 3.5
"M". (fig. B)
For a 3-thread rolled edge, move the stitch selector lever to "D".
Note: These settings may vary depending on thread type and fabric.
A B
C-1
C-2
C-3
O-1
O-2
UL
NEEDLES
O-2
LENGTH
0.75-4.0R
WIDTH
3.5
STITCH
SELECTOR
D
WAVE/OVERLOCK
SELECTOR
OVERLOCK
∧
∨