Baby Lock Ovation (BLES8) Instruction and Reference Guide - Manual (Page 43)

O
V
E
R
L
O
C
K
S
T
I
T
C
H
E
S
E
X
P
R
E
S
S
41
3-Thread Wave Stitch
NEEDLES
O-2
LENGTH
0.75-2.5
WIDTH
5.0
STITCH
SELECTOR
B
WAVE/OVERLOCK
SELECTOR
WAVE
1. Move the Wave/Overlock Selector lever from "OVERLOCK" to "WAVE".
2. Cut the threads from the thread cones, raise presser foot and remove threads from the thread
paths.
3. Engage the threading lever in threading position for threading the loopers. (see page 19)
4. Place the thread cone on the OVERLOCK NEEDLE 2 spool pin.
5. Guide the thread through the telescopic antennae thread guide "O-2" directly above the thread.
Follow the "OVERLOCK NEEDLES 1" threading path down to the "O-2" overlock needle.
6. Thread the O-2 needle using the needle threader. (see page 24)
7. Place the thread cone on the UPPER LOOPER spool pin.
8. Guide the upper looper thread through the telescopic antennae thread "UL" guide directly
above the thread spool. Follow the "OVERLOCK NEEDLES 2" threading path for the UPPER
LOOPER thread, down the front threading path, to the right of the chrome thread guide, and
directly to the "U" threading port for the upper looper. Thread the upper looper. (see page 20)
9. Place the "O-2" needle thread and upper looper thread under the presser foot and to the back.
10. Place the thread cone on the LOWER LOOPER spool pin.
11. Thread lower looper using standard lower looper threading technique. (Refer to Steps 2 - 6 on
page 20)
12. Engage the threading lever to the serging position.
13. Set Stitch Selector Lever on "B" for Wave Stitch.
14. Set Stitch Length and Stitch Width following the suggested settings below.
Note: Recommended settings will vary depending on thread type and fabric.
C-1
C-2
C-3
O-1
O-2
UL
∧
∨