Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part1 - Manual (Page 154)

SEWING THE STITCHES
152
■ Darning
Use darning stitches for mending and other
applications.
Darning is performed by sewing from the front of the
presser foot to the back as shown below.
a Reinforcement stitches
a
Select a stitch, and attach buttonhole foot
“A”.
b
Set the scale to the desired length of the
darning.
a Presser foot scale
b Completed length measurement
c Width 7 mm (approx. 1/4 inch)
d 5 mm (approx. 3/16 inch)
c
Check that the needle drops at the desired
position and lower the presser foot, making
sure the upper thread passes underneath
the buttonhole foot.
d
Lower the buttonhole lever so that it is
positioned behind the metal bracket on the
buttonhole foot.
a Buttonhole lever
a Metal bracket
Stitch Stitch name Presser foot
Darning
Darning
Memo
• The maximum length for darning is 28 mm
(approx. 1-1/16 inches).
Note
• Pass the thread underneath the presser
foot.
• Set the presser foot so that there is no gap
behind the section marked with an “A” (the
shaded area in the illustration below). If
there is a gap, the size of the darning will
not be correct.