Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part1 - Manual (Page 26)

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
24
■ Position “3”
The multi-purpose screwdriver can be positioned
over the screw on the embroidery frame to tighten
the screw after hooping the fabric or when removing
the fabric.
Using the Spool Stand
The included spool stand is useful when using
thread spools with a large diameter (cross-wound
thread). The spool stand can hold two spools of
thread.
■ How to assemble the spool stand
a
Fully extend the telescopic thread guide
shaft, and then rotate the shaft until the two
internal stoppers click into place.
b
Insert the telescopic thread guide into the
round hole at the center of the spool
support, and then use a screwdriver to
securely tighten the screw (a) from the
reverse side.
a Screw
Note
• When rotating the multi-purpose
screwdriver, do not forcefully rotate it in the
direction that it does not rotate; otherwise, it
may break.
1 2 3
4 5 6
7 8 9
No. Part Name Part Code
1 Telescopic thread guide XE0776-001
2 Spool support XE4958-101
3 Spool pin × 2 XA6313-051
4 Screw and washer XC7568-051
5 Spool cap (XL) × 2 XE0779-001
6 Spool holder × 2 XA0679-050
7 Spool cap base × 2 XE0780-001
8 Spool felt × 2 XC7134-051
9 Ring × 4 026030-136
CAUTION
• Do not lift the handle of the machine while the
spool stand is installed.
• Do not push or pull the telescopic thread
guide or spool pins with extreme force,
otherwise damage may result.
• Do not place any object other than spools of
thread on the spool support.
• Do not try to wind thread on the bobbin while
sewing using the spool stand.