Basler Electric DECS-250N - Manual (Page 366)

350 9440500990 Rev D
Revision History DECS-250N
Firmware
Version and Date
Change
1.03.00, Feb-15 •
Added Chinese language
•
Added Generator/Motor operating mode selection
•
Enhanced network load sharing
○ Added Network Load Share metering screen
○
Added Power Input and NLS Error Percent parameter
selections for configurable protection
○
Added status logic elements for Config Mismatch, ID
Missing, and Network Load Share Active
○
Added NLS Broadcast logic element to broadcast alarms
to selected units actively sharing load
•
Added VAR/PF MODE logic element
•
Changed the default value of auxiliary control gains to zero
•
Modified datalog triggering by watchdog
•
Modified the way PF is scaled when used for an analog output
•
Modified display of setpoints
•
Modified datalog to trigger on contact input open
•
Added PF Active Power Level % to Modbus
•
Expanded the range for analog outputs to
–999,999 to 999,999
•
Added Modbus registers for AEM-2020 alarms
•
Modified unsecured access level security
•
Modified communication with IDP-800
•
Modified total VA and total PF calculations
•
Modified frequency display in Comtrade files
•
Modified scaling of RTD values
•
Modified operation of SCL limiter
Table 49. BESTCOMSPlus
® Software Revision History
Software
Version and Date
Change
3.05.03, Mar-14 •
Initial Release
3.06.00, Apr-14 •
Updated to support firmware version 1.02.00
3.07.00, Oct-14
•
Improved graphing of UEL curve
•
Changed UEL Primary Curve screen to allow decimal points when
in per unit mode
•
Removed duplicate results in the device discovery list
•
Improvements to device directory on Connection screen
•
Changed to allow a comma in the Device ID
•
Changed to annunciate a connection failure message when a
device is not present on a selected port
•
Improved prompts to save settings when choosing to close all
open views
•
Changed to allow the middle mouse button to close the security
view
•
Improved display of raw analog input currents
•
Changed to make BESTlogicPlus status LEDs report all logic
errors