Baumatic BHI660BE - Manual (Page 29)

o
IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future, particularly if it needs to be serviced.
o
Carefully lower the hob into the aperture hole that you have cut
out.
o
There are holes on the base of the hob that you can fix the brackets
to.
You should place the bracket on the underneath of the hob, in a
position that is appropriate for the aperture that you have cut out.
Using the screws provided, fix the bracket to the hob. These screws
MUST be securely tightened.
Electrical connection
This appliance must be installed by a qualified
person in accordance with the latest edition of the
I.E.E. Regulations and in compliance with Baumatic’s
instructions.
Before connecting the appliance, make sure that the supply voltage
marked on the rating plate corresponds with your mains supply
voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o
This appliance must be wired into a 32A double pole switched
fused spur outlet, having 3 mm contact separation and placed in
an easily accessible position adjacent to the appliance. It should
not be located above the appliance and no more than 1.25m
away from it.
o
The spur outlet must still be accessible even when your hob is
located in its operating position.
o
Cable type: H05 RRF 3 core x 6 mm² (not supplied).
29