Baumatic BHI660BE User Manual
Page 30
Connecting the mains supply cable
o
The mains terminal block is located on the underside of the hob and the
terminals are accessible by removing the terminal block cover by
removing the cover screw.
o
The brass links must be positioned as
indicated, based on voltage and electrical
connection, and once established ALL terminal
screws must be tightened down firmly.
o
If when the hob is first switched on, only two of the zones work,
you should recheck that the terminal screws are all fully tightened
between the links. This should be done before contacting the
Customer Care Department.
o
IMPORTANT: The appliance must NOT be connected to the mains supply
by means of a 13A plug and socket.
o
The cable can be looped if necessary, but make sure that is not kinked or
trapped when the hob is in position. Care must be taken to avoid the
cable being in contact with hot parts of the appliance.
30