Baumatic BHI660BE - Manual (Page 32)

o
The residual heat indicator has not come on after I have
switched a cooking zone off.
*
The cooking zone has only been turned on for a short period of
time; therefore it did not go above 60°C.
*
IMPORTANT: If the cooking zone does appear to be hotter than
60°C and the residual heat indicator has not come on, you should
call the Baumatic Customer Care Department.
o
A humming sound is heard when a cooking zone is selected.
*
This is normal; the sound will disappear when the zone heats up.
o
The cooking zones have become discoloured.
*
This maybe caused by burnt on remnants of food. This will not
affect the working of the appliance. However you should make sure
that the cleaning instructions are being followed regularly.
o
Only two of the zones on my hob are working
*
You should recheck that the terminal screws are all fully tightened
between the links.
Error codes
The following error codes may appear in the timer display if there is a
problem with the operation of the hob.
Error
code
Likely cause Possible solution
F1-F6 Temperature sensor failure Please contact Customer Care.
F9-FA Temperature sensor of the IGBT
failure.
Please contact Customer Care.
FC The connection between the
display board and the main
board has failed
Please contact Customer Care.
E1/E2 Abnormal supply voltage Check the power supply to the
appliance is correct.
E3/E4 Temperature sensor of the
ceramic glass plate Is high
Turn the power off. Restart after
the hob cools down.
E5 Temperature sensor of the IGBT
Is high
Turn the power off. Restart after
the hob cools down.
IMPORTANT: If any other error codes appear on the cooking
zone display, you should turn the appliance off at the mains
and contact the Customer Care Helpline. DO NOT continue to
use the appliance.