BayTech DS2-RPC 2012 User Manual

Page 21

Advertising
background image

Page

21 

DS4(A)­RPC Receptacle Controls: 

­­On, Off, Reboot, Lock, and Unlock 






















Status 












Config 


Current 





The {REBOOT n} command will reboot or reset equipment attached to corresponding receptacle(s).
When the command to REBOOT is sent from the DS-RPC > prompt, the DS powers ‘Off’ the
corresponding outlet(s) for approximately 10 seconds, then powers them ‘On’ in sequence.
This command only works on outlets which were ‘On’ prior to receiving the reboot command

On, Off, Reboot, Lock, and Unlock are commands to control the
individual outlets. From the (DS-RPC >) prompt, enter one of the
following commands: {ON n}, {OFF n}, {REBOOT n}, where “n” is the
outlet number you want to command.


Example: To turn ‘On’ Outlet 3, type “ON 3” from the DS-RPC prompt.
The DS responds with:

Circuit Breaker: On

1)...Outlet 1 : On
2)...Outlet 2 : On
3)...Outlet 3 : On
4)...Outlet 4 : On

DS-RPC>on 3

Turn On Outlet 3 (Y/N)?y

Type “Y” for yes turns ‘On’ Outlet 3. Observe the status of Outlet 3 has changed to ‘On’ in the status
menu. Likewise, typing ‘ON ALL’, ‘ON 0’, or ‘ON’ at the DS-RPC > prompt and responding “Y” for
yes, turns ‘On’ all outlets. The {OFF n} command work similarly as the {ON n} command.

The {Lock n} command will lock the outlet in its current state, On or Off. The {Unlock n} command
unlocks the outlets to allow them to change states, On, Off, or Reboot.

NOTE: Only the Admin user will have the {Lock n} and {Unlock n} options.

Type “Current” at the prompt to show
the unit’s True RMS Current and Peak
RMS Current, and the unit will display
the following:

DS-RPC>current

True RMS Current: 0.2 Amps Maximum Detected: 0.2 Amps

Type "Help" for a list of commands

Average Power: 0 Watts Apparent Power: 29 VA

True RMS Voltage: 121.1 Volts

True RMS Current: 0.2 Amps Maximum Detected: 0.2 Amps

Internal Temperature: 33.5 C

Outlet Circuit Breaker: Good

1)...Tester 1 : On
2)...Test 2 : On
3)...Outlet 3 : On
4)...Outlet 4 : On

This shows the current status of
the unit RPC: Voltage, RMS
Current, Maximum Detected
Current, state of circuit breaker,
Average Power, Apparent Power
and Internal Temperature.

Refer to previous section on DS4 (A)-RPC CONFIGURATION MENU.

Advertising