Bebe Confort Natural Comfort Electric Breast Pump - Manual (Page 16)

16
FR
PT
IT
EN
NL
ZH
ES
RU
NATURAL COMFORT ELECTRIC BREAST PUMP
1- Safety information
Please read the instructions in full before using the breast pump.
When using electrical equipment it is important to comply with safety precautions including those set out below.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical sensory
or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be made by children without supervision.
• If the power supply cable is damaged, it must be replaced by a special cable or assembly available from the
manufacturer or its service agent.
Additional recommendations:
• The appliance is only to be used with the power supply unit provided with the appliance.
• Begin by plugging the power cord into the Natural Comfort breast pump, then attach it to the USB power supply.
• Always unplug the device immediately after use.
• The breast pump must be used in a vertical position.
• Never pick up an electrical appliance which has fallen into water. Unplug it immediately.
• Keep the device dry and protect it from direct sunlight.
• Only use genuine Bébé Confort accessories.
• Check the various parts of the breast pump for signs of wear or damage.
• The shield and tube are for personal use only. For hygiene reasons they must never be used by another person.
PRECAUTIONS RELATING TO BATTERIES:
• Use only alkaline or rechargeable (NiMH) batteries.
• DO NOT charge non-rechargeable batteries.
• Do not mix different types of battery and do not mix old and new batteries.
• When inserting the batteries, ensure the polarity is correct.
• Remove discharged or dead batteries from the device, remove the batteries if the device is to remain out of use for an extended period of time.
• Do not short circuit the battery terminals.
• Ensure all contact surfaces are clean before inserting the batteries.