Bebe Confort Natural Comfort Electric Breast Pump - Manual (Page 18)

18
NB: The automatic rinse cycle built into the product guarantees the tube is clean and can be reused in total safety within seven hours.
The rinse must be carried out soon after using the device, within a maximum of two hours, to ensure the milk does not dry in the tube.
If seven hours have passed since the tube was last rinsed, we recommend you sterilise it.
To sterilise the tube (H) and the nozzle (M) in a microwave, use the accessories provided and follow the instructions in
appendix V
:
1. Plug the flexible end of the tube (H) into the reservoir (S) and wrap the tube around it. Check that there are no kinks in the tube!
2. Fill the reservoir (S) with water up to the line inside (1cm from the top).
3. Screw on the lid (R), blocking the tube (H) and nozzle (M) into the notch.
4. Clip the top (Q) over the lid (R).
5. Place in the microwave (top facing up) for the relevant time as shown below:
Power in Watts 900 700 550
Time 6 mins 7 mins 8 mins
Alternatively, you can sterilise the tube (H) and nozzle (M) in boiling water or by using cold water sterilising tablets.
1. In both cases, please ensure no air bubbles remain in the tube (H).
Cleaning other parts of the breast pump, see the
appendix II
.
The breast pump (A) and cover (B) should be cleaned with a damp cloth. Do not use solvents or alcohol.
4- Assembling the pump before use (see appendix III)
Wash your hands thoroughly before starting to assemble your breast pump.
1. Assemble the lid. Press down firmly on Lid (B) + Transparent diaphragme (E) + Bottle ring (C ) + One-way valve (F).
2. Check that all parts are properly assembled!
3. Connect the lid (B) to the rest of the device (A).
4. Plug in your breast pump:
• Using power cable (K + L) OR
• By connecting it to a USB power source (L) OR
• Using four AA alkaline or rechargeable batteries with a minimum capacity of 1800mAh.