Belshaw Adamatic TG50 Thermoglaze - Manual (Page 7)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Thermoglaze 50 MN-1720WM 1
1 Unloading and Uncrating
DO NOT LIFT EXCESSIVE
WEIGHT
Once the crate has been delivered,
immediately take the covers off the crate and
inspect for hidden damage. If damage is
found, make a damage claim to the shipping
company. After inspection, cut the banding
and remove any other restrains from the
Thermoglaze unit. Remove the banding and
other packing material from the Thermolizer
unit. Roll the Thermolizer, carefully, off the
skid first and move it near the area where it
will be assembled. Roll the Thermoglaze
unit, carefully, off the skid and move it near
the area where it will be assembled.
Do not connect the Thermoglaze or the
Thermolizer to electrical power before
completing the assembly and placement of
the products.
Figure 1-1 shows the system in the crate ready to
be unpacked. The cartons under the Thermoglaze
contain the glaze trough. See Section 4 to
assemble the unit. The carton in the Thermolizer
contains the doors and other interior parts. See
Thermolizer manual for assembly instructions.
The Thermoglaze system has been designed for
quick assembly and installation. Within a short
time of receiving the system, the installer can
have the Thermoglaze ready to make donuts if
the electrical connections are properly installed
and inspected by the prevailing local authorities.
Figure 1-1 Packed Thermoglaze System