Beurer FWM 40 - Manual (Page 12)

12
IMPORTANT
• Please note that the foot warmer must not be washed, chemically cleaned, wrung out, tumble dried,
put through a mangle or ironed. Failure to observe this may result in damage to the foot warmer.
The removable fleece lining can be washed by hand.
Use a delicate laundry detergent and measure it out according to the manufacturer’s instructions.
WARNING
• Only use the foot warmer again once the foot warmer and fleece insert have fully dried. Otherwise,
there is a risk of damage.
6. Storage
If you do not plan to use the foot warmer for a long period of time, we recommend that you store it in the
original packaging.
IMPORTANT
Allow the foot warmer to cool down before storing. Failure to observe this may result in damage to the
foot warmer. To avoid damaging the foot warmer, do not place any objects on top of it whilst storing.
7. Disposal
Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and
Electronic Equipment). If you have any questions, please contact the local authorities responsible
for waste disposal.
8. What if there are problems?
Problem Cause Solution
The foot warmer does not warm up or the massage
function cannot be activated while:
– the mains part is connected to a working socket.
– the foot warmer controller is connected to the mains
part cable.
– both sliding switches are set to setting 2 (heat +
massage).
The foot warmer is
faulty. Send the foot warmer
for servicing.
9. Technical data
See type plate on the foot warmer controller.