Beurer BC 80 - Manual (Page 23)

23
• Start individual measurement access.
• Press and hold the M1 & M2 memory buttons for 5 sec-
onds.
CL and 00 appear on the display.
All the values in the current user memory
are deleted.
The device will then switch off automati-
cally.
7. Transferring measurements
Connect the blood pressure monitor to your PC using the
USB cable.
No data transfer may be launched whilst performing a
measurement.
PC is shown on the display. Begin the data
transfer in the “HealthManager” PC software.
During the data transfer, an animation is
shown on the display. A successful data
transfer is displayed as in figure 1. If the data
transfer is unsuccessful, an error message
appears as in figure 2. In this case, interrupt
the PC connection and start the data transfer
again.
After 30 seconds of not being in use or if
communication with the PC is interrupted,
the blood pressure monitor switches itself off
automatically.
8. Error messages/troubleshooting
In the event of errors, the error message E_ appears on the
display.
Error messages may appear if:
• It was not possible to record the pulse: E 1;
• You move or speak during the measurement:: E2 ;
• The cuff is fastened too tightly or loosely: E3;
• Errors occur during the measurement: E4;
• The pump pressure is higher than 300 mmHg: E5;
• The batteries are almost empty E6.
In such cases, repeat the measurement. Ensure that you
do not move or speak. If necessary, reinsert or replace the
batteries.
9. Cleaning and maintenance
• Clean your blood pressure monitor carefully using a slightly
damp cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances should you hold the unit under
water, as this can cause liquid to enter and damage the
unit.
• Never place any heavy objects on the device.
figure 1
figure 2