Beurer BM 65 - Manual (Page 22)

22
• To prevent possible damage to the device, the blood
pressure monitor must only be used with the mains part
described here.
• Insert the mains part into the connection provided for
this purpose on the right-hand side of the blood pressure
monitor. The mains part must only be connected to the
mains voltage that is specified on the type plate.
• Then insert the mains plug of the mains part into the
mains socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it
from the blood pressure monitor. As soon as you unplug
the mains part, the blood pressure monitor loses the
date and time setting but the saved measurements are
retained.
5. Measuring blood pressure
Please ensure the device is at room temperature before
measuring.
Positioning cuff
Fit the cuff round your bare left
upper arm. Blood circulation in the
arm should not be restricted by
tight clothing or other objects.
The cuff should be placed on the
upper arm so that the lower edge
is 2 to 3 cm above the bend of the
elbow and above the artery. The
tube should be in line with the
centre of the palm.
Now place the free end of the cuff
snugly, but not too tightly, around
the arm, and fix it with the Velcro
fastener. The cuff should be fitted
tight enough to allow just two fin-
gers to fit beneath the cuff.
Insert the cuff tubing into the socket
for the cuff attachment.
Important: The device may only be
operated with the original cuffs. The
device comes with 2 cuffs: a stand-
ard cuff for arm circumferences of 22 to 30 cm and a larger
cuff for upper arm circumferences of 30 to 42 cm.