Beurer GS 485 - Manual (Page 12)

12
Place the scale on a firm level floor; a firm floor covering is required for correct measurement.
– activate Bluetooth
® in the smartphone settings.
note: Bluetooth Smart devices, such as this scale, are not visible in the general system settings of the
Bluetooth device list. Bluetooth Smart devices are visible only in special apps or in device manufacturer
apps.
– Install “Beurer healthmanager” from the app Store
– Start the app and follow the instructions.
– Switching on the scale
note: Before you can select the GS 485 in the app, the scale must be switched on before each syn-
chronisation. In order to switch on the scale, briefly apply pressure to the scale with your foot.
– Select GS 485 in the app.
– enter the GS 485-related data.
The following settings must be set or entered in the “Beurer Healthmanager” app:
User data Parameters
Initials / abbreviation of name max. 3 characters or numbers
Body height
100 to 220 cm (3‘ 3.5“ to 7‘ 2.5“)
Age 10 to 100 Years
Sex man ( ), woman ( )
Degree of activity 1 to 5
Degrees of activity
Selection of the degree of activity must refer to the medium and long term.
Degree of activity Physical activity
1
None.
2
Low: A small amount of light physical effort (e.g. short walks, light garden work,
gymnastic exercises).
3 Medium: Physical effort for 30 minutes at least 2 to 4 times a week.
4 High: Physical effort for 30 minutes at least 4 to 6 times a week.
5
Very high: Intensive physical effort, intensive training or hard physical work for at
least one hour daily.
– assign the user when requested to do so by the app.
For automatic personal recognition, the first measurement must be assigned to your personal user data.
Follow the app instructions for this. Step onto the scale and ensure that you are standing still with equal
weight distribution and with both legs on the standing surface.
8. Taking measurements
Weighing, carrying out diagnostics
Now step on the scale. Stand still with your weight distributed equally on both feet. The scale begins to
take measurements straight away.
The weight is displayed.
If a user has been assigned then the BMI, BMR and AMR are displayed. This is the case if the initials are
shown.
If the user is not recognised, only the weight can be shown and no initials appear “ ”.
Switching off the scale
The scale will then switch itself off automatically.