Blu Bathworks LF1062 - Manual (Page 6)

2014-01
1 866 907 0122 blubathworks.com
®
5
Toilet Tank Fill Valve Instruction (if necessary)
Note: Fill Valve Height has been preset at the factory and DOES NOT require any height adjustment
INSTALLATION
1. Shut off the water supply to the toilet.
2. Flush toilet and remove remaining water from tank with a sponge.
3. Remove the water supply connection at the fill valve.
4. Remove old fill valve and use damp sponge to clean hole in tank.
5. Place new fill valve inside tank hole.
6. Thread mounting nut onto fill valve shank and tighten the nut.
Note: Do not over-tighten. Be sure to install fill valve in a position that does not interfere with the trip lever operation.
7. Connect water supply to fill valve shank and hand-tighten only.
Note: Do not overtighten. These are plastic parts. Never use pipe dope on any water supply connection.
8. Attach refill tube to fill valve nipple and clip other end of refill tube to the overflow pipe.
9. T urn water supply ON and check for leaks outside the tank.
Note: As water fills the tank, water is also directed into the overflow tube via the refill tube. This additional flow
of water is critical to refilling your toilet’s bowl. Once the water stops filling the tank, some residual drops of
water may drip from the fill valve. This is NORMAL as these drops will subside.
5
6
Connecting Water Line
Install the Toilet Lid (LF8004)
The supply stop should be installed per the supply stop instruction at
the location shown in the Before Installation section. Flush the water
line briefly to ensure removal of debris. Connect flexible supply hose to
supply stop.
CAUTION: HAND-TIGHTEN ONLY.
Open the supply stop, checking for leakage. Slightly re-tighten if
necessary. The water supply pressure should be 20 to 80 psi static.
• Carefully place lid on top of tank, making sure that the push rod colours match the flush valve buttons
(blue to blue, white to white).
• To replace or readjust the push rod height, push down on one button while pulling the opposite button
up with your finger to remove.
• Use the provided longer push rod, and insert them through the push button housing.
• Cut the push rod at the shown location.
• Install the rods into the push buttons and insert the bittons in the housing until they click into place.
• When insterting the buttons, make sure that the rod colours match with the flush valve button colours
(blue to blue, white to white).
Water Inlet
Washer
Coupling Nut
Trim Plate
Nipple
Valve
Compression
Valve Nut
Flexible Supply
Hose (not supplied)
Fig. 4