BSS Audio sw9016 Install Guide - Manual (Page 3)

Soundweb 9016 Installation Guide
3
Soundweb
TM
Mechanical Installation
If the unit is likely to undergo extreme vibration through extensive road trucking and
touring, it must be supported at the rear and/or sides to lessen the stress on the front
mounting flange. Use either a ready-built rack tray or mount the 9016 unit between other
units. Damage caused by insufficient support is not covered by the warranty.
To prevent cosmetic damage to the front panel finish, use protective plastic cups under
the rack mounting bolts.
Error
Blinks when a malformed serial
message has been received, or an
error has occurred within the unit.
Power
When illuminated, indicates that the
power supply
is functioning.
Activity
Flashes when a command is
being processed.
User
The unit is operating at a user-
definable serial bitrate.
Front Panel LED Functions
Zone
The unit is operating in zone mode with no presets loaded into it. Voltages presented to the
control port switch stereo pairs of inputs to stereo pairs of outputs, with video following audio.
Preset
The unit is operating in preset
mode. Voltages presented to
the “Z1” section of the
control port will recall
presets from memory.
Device A
The unit is addressed as device A.
Device B
The unit is addressed as device B.
Soundweb
The unit is operating at the correct
serial bitrate for connection to a
Soundweb unit (38400bps)