BSS Audio sw9010 Install Guide - Manual (Page 2)

112
Soundweb
TM
Regulatory Information
An example of this equipment has been tested and found to comply with the following European
and international Standards for Electromagnetic Compatibility (only when used with a metal
wallbox).
Radiated Emissions (EU):
EN55022 (1990) Associated Equip.
Immunity (EU): EN50082/1 (1992) RF Immunity, Fast
Transients ESD
Radiated Emissions (USA): FCC part 15 Class A
v1.0 PW/JMK 21st March 1999
Important safety information - read and follow
It should not be necessary to remove any protective earth or signal cable shield
connections to prevent ground loops. Any such disconnections are outside the
recommended practice of BSS Audio, and will render the EMC certificate void.
We have written this guide with the aim of helping installers and sound engineers alike to
get the most out of the 9010. We recommend that you read this manual, particularly the
section on installation, before attempting to operate the unit.
We welcome any comments or questions regarding the 9010 or other BSS products, and
you may contact us at the address or World Wide Web site given in the warranty section.
Mechanical Installation
The 9010 is designed to fit into a standard 3-gang US wallbox. Screws are provided to fix
the unit in place. An optional bezel is available to ‘dress’ the edges of the panel if
required.
Dimensions of the unit are shown below. BSS recommend the use of a metal wall box to
ensure that the installation meets necessary EMC standards. If you require suitable
wallboxes, contact your distributor
for part Z-010-BOX.