Denon DVD-2930CI - Manual (Page 27)

ENGLISH
ENGLISH
Making the initial settings Making the initial settings
24
Use [D D H H] to select the item to be set, then press
[ENTER] .
2
Use [D D H H] to select “BASS ENHANCER”, then press
[ENTER] .
1
OFF (Upon purchase):
No sound is output from the subwoofer.
Sets the subwoofer output for when playing 2-channel or other
sources without LFE signals.
ON:
Sound is output from the subwoofer.
Set “SUBWOOFER” at “SPEAKER CONFIGURATION” to “YES”.
1
2
Use [D D H H] to select the item to be set, then press
[ENTER] .
2
Use [D D H H] to select “COMPRESSION”, then press
[ENTER] .
1
OFF (Upon purchase):
The sound is played with the standard dynamic range.
ON:
Select this to achieve a powerful sound even when the volume is
low.
This setting is suited for use at night with the volume set low.
1
2
Bass enhancer
Use this procedure to set the dynamic range of the output signals
when playing DVDs recorded in Dolby Digital.
Dynamic range compression
• This setting is only effective for analog outputs.
• This setting is ineffective when “SOURCE DIRECT” is set to
“50kHz” or “100kHz”.
• Dynamic range:
This is the ratio between the softest sound that can be played
without being drowned out by the noise generated by the
equipment and the loudest sound that can be produced without the
sound breaking up.
• When setting “100kHz”, first check the range of the connected
amplifier and speakers to avoid damage to the connected
equipment.
• When setting “50kHz” or “100kHz”, set all the speaker sizes to
“LARGE” and the subwoofer to “YES”. Make analog connections if
you want to play DVD-Audio discs.
• The “CHANNEL LEVEL” and “DELAY TIME” settings remain in
effect even when “50kHz” or “100kHz” is set.