Caple C240SS - Manual (Page 13)

13
°
C
The temperature set is shown on the electronic programmer
display and can be varied, with 5°C intervals, by turning the
potentiometer knob.
During the cooking the oven temperature is measured by a
sensor inside the cavity and is shown on the programmer
display.
1.
SELECTING THE COOKING FUNCTION
Turn the selector knob to the cooking function requi-
red
The pre-set temperature appears on the programmer
display.
°C flashes on the display for 3 seconds. The hea-
ting elements start cooking immediately.
2.
SETTING THE COOKING TEMPERATURE
Turn the potentiometer knob clockwise to increase the
temperature or anticlockwise to reduce it.
The maximum temperature which can be set is 250°C
while the minimum temperature is 50°C.
Note: When °C becomes steady the value shown on the
display indicates the oven cavity temperature.
Caution: If a temperature below the minimum value (50°C)
is set the system switches off automatically and
OFF
appears.
In this case repeat the procedure from point 2.
The temperature can also be set by means of the programmer
keypad operating as in point 2 of the previous page.
3.
SWITCHING OFF
Turn the selector knob to position
0 (oven OFF).
The programmer display shows the time.
SETTING THE COOKING (ONLY FOR THE COOKING FUNCTIONS)
Models with temperature knob (potentiometer)
A U T O
P
° C F
0
° C
P P
Function
selector knob
Programmer
Temperature
knob
0
F
I
I
I I
I
I
I
I
I I I
I
I
➀
➁
➂
Fig. 2.3
NOTE: The temperature knob (potentiometer) turns to right and left only to sym-
bols + and -. Forcing the turning could irreparably damage the temperature knob.