DMP Electronics XR2500F - Manual (Page 18)

Digital Monitoring Products XR2500F Installation Guide
10
IntRoduCtIon
7.9 Notification
The user must not repair registered terminal equipment. In case of trouble, immediately unplug the device
from the telephone jack. The factory warranty provides for repairs. Registered terminal equipment may
not be used on party lines or in connection with coin telephones. No tify the telephone company with the
following information:
a. The particular line(s) where the service is connected
b. The FCC registration number
c. The ringer equivalence
d. The device make, model, and serial number (see the serial # sticker on the panel)
7.10 FCC Registration
The Model XR2500F complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On
the outside of the enclosure of this equipment is a label that contains, among other information, a product
identifier in the format US:CCKAL00BXR500. If requested this number must be provided to the telephone
company.
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and requirements adopted by the ACTA. See installation instructions
for details.
The Ringer Equivalence Number (REN) is used to determine the number of devices that may be connected
to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to
an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of
the number of devices that may be connected to a line, as determined by the total RENs, contact the local
telephone company.
If the XR2500F causes harm to the telephone network, the telephone company will notify you in advance
that temporary discontinuance of service may be required. But if advance notice isn’t practical, the
telephone company will notify the customer as soon as possible. Also, you will be advised of your right to
file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that could
affect the operation of the equipment. If this happens the telephone company will provide advance notice
in order for you to make necessary modifications to maintain uninterrupted service.
If trouble is experienced with the Model XR2500F, for repair or warranty information, please contact DMP at
the address and telephone number listed on the back of this document. If the equipment is causing harm to
the telephone network, the telephone company may request that you disconnect the equipment until the
problem is resolved.
If your premises has specially wired alarm equipment connected to the telephone line, ensure the
installation of the XR2500F does not disable your alarm equipment. If you have questions about what will
disable alarm equipment, consult your telephone company or a qualified installer.
Caution: To ensure proper operation, this equipment must be installed according to the installation
instructions in this manual. To verify that the equipment is operating properly and can successfully report an
alarm, this equipment must be tested immediately after installation, and periodically thereafter, according
to the test instructions in this document and the XR500 Series Programming Guide (LT-0679). Additionally,
verification of Line Seize capability should be made immediately after installation, and periodically
thereafter, in order to ensure that this equipment can initiate a call even when other equipment (telephone,
answering system, computer modem, etc.) connected to the same line is in use.