Installing the print cartridge – Dell fi-565PR User Manual

Page 11

Advertising
background image

fi-565PR Imprinter Operator’s Guide | 7

10. Replace the Stacker (removed in procedure 2)

into the Imprinter.

11. Connect the power cable to the scanner.

2.2. Installing the Print Cartridge

Mount the print cartridge as follows:

ATTENTION

When installing or replacing the print cartridge, be
careful not to insert it out of place.

1. Confirm that the scanner is turned off.

2. To open the print cartridge cover, grasp and pull

open the center of the cover turning it towards
you, as shown below.

3. Remove by pulling the tape seal that is affixed to

the print cartridge holder and the paper guide.

4. Pinch slightly together the handles of the closing

lever to release it from its cartridge tray holder
and turn it upwards to open the tray holder.

5. Remove the new print cartridge from its pouch.

6. Remove protection tape from the print cartridge.

ATTENTION

Do not touch the metal part of the cartridge nor
put the tape back on again.


7. Insert the print cartridge into the holder as shown

below.

ATTENTION

Be careful not to let the print cartridge touch or
catch on to the print circuit film.

8. Lower the handle lever until it locks in and fixes

the cartridge in place.

9. Position the print cartridge holder along where the

document will pass through.

Ö The print will be located on the page properly for

your application.

Print Cartridge Holder

c

Insert one end.

d

Insert the next end.

Advertising