Dell fi-565PR - Manual (Page 12)

8 |
10. Close the print cartridge cover.
2.3. Operating Test
After installing the imprinter, test to see if printing can be
performed on the Offline Print Test mode.
1. While pressing the [Function] button (U or V) on
the operator panel, switch on the scanner.
Continue pressing on the [Function] button.
2. Release the [Function] button when the Function
Number Display changes from [P] to [b].
3. Place a blank document on the ADF paper chute.
ATTENTION
● Use A4 or Letter size paper. If the size is
smaller than A4 or Letter, printing may not
successfully complete.
● Confirm that the Print Cartridge is
positioned within the document width.
4. Press [Scan] button to test.
Ö Paper will feed into the ADF, and the Imprinter will
print out the Print Test Characters starting at 5mm
from the paper’s edge.
HINT Print test patterns
Test pattern 1 (Horizontal):
ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`00000000
Test pattern 2 (Horizontal）:
abcdefghijklmnopqrstuvwxyz{|}~ 00000000
Test pattern 3 (Horizontal):
!”#$%&()*+,-./0123456789:;<=>?@00000000
Test pattern 4(Vertical):
ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`00000000
Test pattern 5 (Vertical):
abcdefghijklmnopqrstuvwxyz{|}~ 00000000
Test pattern 6 (Vertical):
!”#$%&()*+,-./0123456789:;<=>?@00000000
When multiple sheets of documents are placed in
the ADF, the Test Print repeats patterns from 1
through 6.
The numbering data portion “00000000” changes
from 0 (Zero) with increment of 1(one).
(One test pattern is printed at a time. Press the
[Scan] button to continue printing the next test
pattern.)
5. To stop Offline Print test mode, turn off the
Scanner.
Function
Send to Scan
Function Function
Function Number
Display
[Function] button
5mm
Feeding direction
Print Test Sample
c d e f g h