Code Blue IA4100 SINGLE BUTTON ANALOG SPEAKERPHONE - Manual (Page 26)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-139-J page 26 of 29
IA4100
Administrator Guide
General Programming
How do I program an analog emergency speakerphone or “call box”?
To program an IA4100, IA3100 and IA500 series phone, you need to use an analog phone or an IP
phone that pushes DTMF tones and call the extension or phone number of the Emergency phone.
When you dial the phone number to the Code Blue speakerphone you’re trying to reach, you will
hear an acknowledgement tone or RFA tone to let you know that the phone has picked up and is
ready to be programmed. Then press the programming password for that particular model phone to
enter programming mode and configure the phone.
For example, to program an IA4100:
Call into the speakerphone or “call box”, press 12583# and wait for acknowledgement tone,
01 <phone number> #, wait for acknowledgement tone, then press * # to hang up.
Where can I find speakerphone programming manuals?
http://codeblue.com/Support/TechnicalSupport/downloads or Email [email protected])
IA4100 Speakerphone
How do I program the IA4100 to work on a ring-down line?
5. Call Code Blue speakerphone’s phone number and enter program mode (1<password>#).
6. Enter 5000 #. This will set the IA4100 to operate in ring-down mode.
7. Enter * # to save and exit programming.
How do I get the IA4100 phone to hang up after the called party hangs up?
By default, the IA4100 is looking for a 200-millisecond WINK to hang up the call. If your phone
system is not issuing a 200-millisecond WINK there are additional hang-up methods available, such
as monitoring for dial tone, reorder tones or silence. If you know the type of disconnect or hang-up
method your phone system uses, then just enable the one you need via programming. If not, you
can turn them all on.
The alternate hang-up methods available are:
Revert to dial tone: CMD 41 (Default=00)
Continuous sound for this period will initiate hang-up
Recommended 4108#
Silent Time Out: CMD 42 (Default=0#)
1 to 9 (10 to 90 in 10-second increments)
Recommended 422#
Reorder tones “busy tones”: CMD 43 (Default= 00#)
Number of reorder tones (01 – 99 = 1 -99 cycles)
Recommended 4308#