Comtech EF Data DMD20 - Manual (Page 46)

DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol Remote Operations
MN-DMDREMOTEOP Revision 9 1–36
<1> Asynchronous In-
Band Rate
0 =150, 1 = 300, 2 = 600, 3 = 1200, 4 = 2400, 5= 4800,
6 = 9600, 7 = 19200, 8 = 38400, 9 = 57600, 10 =
115200
<1> FSK Communications
Select
0 = None, 1 = Codan, 2 = TerraSat, 3 = Amplus
<1> FSK Test Type 0 = None, 1 = Loopback, 2 = Cycle TX Enable, 3 =
Codan Pass thru, 4 = TerraSat pass thru, 5 = Amplus
Pass thru, 6 = Query for address
<2> BUC Address
<1> BUC Output Enable 0 = Disabled, 1 = Enabled
<1> Minor Alarm Relay
Usage 0 = undefined, 1= IBS Usage, 2 = IBS & Minor Alarms,
3 = IBS, Minor Alarms and Major Alarms
<1> Ethernet QOS Type 0 = Normal, 1 = Port based
<1> Ethernet QOS
QUEUE
0 = Fair Weighted, 1 = Strict Priority
<1> EBEM overhead
channel rate
0 = Off, 1 = 8K, 2 = 16K, 3 = 24K, 4 = 32K, 5 = 40K, 6
= 48K, 7 = 56K, 8 = 64K
<1> EBEM embedded
channel
0 = Off, 1 = On
<1> EBEM ITA 0 = Disabled, 1 = Enabled
<1> EBEM encryption 0 = Disabled, 1 = Enabled
<4> EBEM Ethernet rate 4800 to 52000000
<1> Ethernet HDLC 0= Radyne, 1 = Comtech, 2 = Managed 570
Opcode: <2602h>
Command a Modulator’s Frequency
Command Data (4 Bytes)
<4> Frequency Selects the IF Frequency in Hz, IF Range = 50 MHz to
180 MHz, L-Band Range = 950 MHz to 2050 MHz
This command also turns the carrier off to protect
the satellite.
Opcode: <2603h>
Command a Modulator’s Strap Code
Command Data (2 Bytes)
<2> Strap Code Binary value
This command also turns the carrier off to protect
the satellite.
Opcode: <2604h>
Command a Modulator’s Data Rate
Command Data (4 Bytes)