Comtech EF Data DMD20 - Manual (Page 71)

DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol Remote Operations
MN-DMDREMOTEOP Revision 9 1–61
<1> Ethernet Bridge Port
4 Status 0 = Down, 1 = Unresolved, 2 = 10 Mbps Half, 3 = 100
Mbps Half, 4 = 10 Mbps Full, 5 = 100 Mbps Full, 6 =
Port Not Used, 7 = 1000 Mbps Half, 8 = 1000 Mbps
Full
<1> Ethernet Bridge WAN
Status 0 = Down, 1 = Unresolved, 2 = 10 Mbps Half, 3 = 100
Mbps Half, 4 = 10 Mbps Full, 5 = 100 Mbps Full, 6 =
Port Not Used, 7 = 1000 Mbps Half, 8 = 1000 Mbps
Full
<4> RFM AGC Voltage Rx AGC Voltage Level in Volts. There is an implied
decimal point. A value of 450 corresponds to 4.50V
<1> RFM AGC Voltage
Sign If <> 0, '-' AGC Voltage
<4> Carrier-in-Carrier Run
Time Delay
Delay in µsec X 10
<4> Carrier-in-Carrier Run
Time Frequency
Offset
Offset in KHz X 10
<2> Carrier-in-Carrier
Ratio
Ratio in dB
Opcode: <2406h>
Query a Demodulator's Latched Alarms
Query Response (8 Bytes)
<1> Latched Alarm 1 Bit 0 = Receive FPGA/Processor Fault
Bit 1 = Carrier Loss
Bit 2 = Multiframe Sync Loss
Bit 3 = Frame Sync Loss
Bit 4 = IBS BER Alarm
Bit 5 = Satellite AIS
Bit 6 = Rx Data Activity
Bit 7 = Rx AGC Level
0 = Not Latched, 1 = Latched
<1> Latched Alarm 2 Bit 0 = Buffer Underflow
Bit 1 = Buffer Overflow
Bit 2 = Buffer Under 10%
Bit 3 = Buffer Over 90%
Bit 4 = RS Decoder Lock Fault
Bit 5 = RS De-Interleaver Fault
Bit 6 = RS Decoder Uncorrectable Word
Bit 7 = Reserved
0 = Not Latched, 1 = Latched
<1> Latched Alarm 3 Bit 0 = Rx L-Band Synthesizer Lock
Bit 1 = Insert DSP Config
Bit 2 = Buffer Clock PLL Lock Detect
Bit 3 = Viterbi Decoder Lock
Bit 4 = Sequential Decoder Lock
Bit 5 = Rx Test Pattern Lock
Bit 6 = External Reference PLL Lock
Bit 7 = Rx Carrier Level
0 = Not Latched, 1 = Latched