Comtech EF Data SDM-9220 User Manual
Page 138
SDM-9220/9230 Hardware Installation Guide
9-10
Memotec Inc.
7.
Configure the Push to Talk mode parameter according to the requirements of your
application scenario:
-
Scenario 1: Where a control station communicates with a remote mobile
location (see
“Push-To-Talk Application: Scenario 1” on
):
On the button side of the connection, set Push to Talk mode to PTT
CONTROL.
This is required for the air traffic controller (Unit 2) in Scenario 1 (see
).
On the mobile unit side, set the Push to Talk mode to PTT ANSWER.
This is the default value.
-
Scenario 2: Where there are two remote locations (see
To-Talk Application: Scenario 2” on page 9-7
):
On both sides of the connection, set Push to Talk mode to PTT CON-
TROL.
TIP:
As a general rule of thumb in any PTT application, if the PTT device has a
control button, you can set the corresponding E&M/PTT channel to PTT
CONTROL.
8.
Change the other channel parameters from their default values, if desired.
Analog channel configuration parameters are detailed in the appendix SE/SLOT/#/
CHANNEL Configuration Parameters in the Analog Voice module of the
NetPerformer Reference Guides.
SE/SLOT/#/
CHANNEL
example
SDM-9230>SE
SETUP
Item (BRIDGE/CALLER ID/CLASS/CUSTOM/FILTER/GLOBAL/HUNT/IP/IPX/MAP/
PHONE/
PORT/PU/PPPOE/PPPUSER/PVC/REDUNDANCY/SCHEDULE/SLOT/USER/VLAN,
def:BRIDGE) ? SLOT
SLOT> Slot number (1/2/3,def:1) ? 3
Item (LINK/CHANNEL,def:LINK) ? CHANNEL
SLOT> Port number (1-4/ALL,def:1) ?
VOICE 301> Protocol (def:OFF) ? ACELP-CN
VOICE 301> DSP packets per frame 1234
VOICE 301> 8K packetization selection (Y/N) ? YNNN
VOICE 301> DSP packets per frame 12345
VOICE 301> 6K packetization selection (Y/N) ? NNNNN
VOICE 301> Comfort noise level (def:0) ?
VOICE 301> Analog E&M type (def:4 WIRE) ?
VOICE 301> TE timer (s) (0-255,def:0) ?
VOICE 301> Push to Talk mode (def:PTT ANSWER) ? PTT CONTROL
VOICE 301> Local inbound voice level (db) (def:0) ?
VOICE 301> Local outbound voice level (db) (def:-3) ?