Comtech EF Data SDR-54A - Manual (Page 19)

Chapter 2. Installation
This chapter provides unpacking, installation instructions.
2.1 Unpacking
The demodulator and manual are packaged in pre-formed reusable cardboard cartons
containing foam spacing for maximum shipping protection.
To remove the unit from the box, proceed as follows:
CAUTION
To avoid damage to the unit, do not use any cutting tool, which will extend
more than 1 inch into the container.
1. Cut the tape at the top of the carton, where it is labeled “OPEN THIS END.”
2. Lift out the cardboard/foam spacer covering the demodulator.
3. Remove the demodulator, manual, and power cord from the carton.
4. Save the packing material for reshipment.
5. Inspect the equipment for damage incurred during shipment.
6. Ensure the shipment is complete by checking the equipment against the packing
list shipped with the equipment.
7. Refer to Section 2.2 for system installation instructions.
2–1