3 remote protocol factory default setup, 5 storage – Comtech EF Data MD2401 User Manual
Page 23
MD2401 L-Band Multi Demod Installation and Operation Manual
Installation
MN-MD2401
2–5
Revision 7
2.4.3 Remote Protocol Factory Default Setup
Demodulator will be configured with default settings when they are shipped from factory. Refer to
section 5.6 to Defaults setting can be modified may be The default settings for the RS485
Communication port are:
Table 2-1. S1 DIP Switches
Demodulator
Location
Position
1
Position
2
Position
3
Position
4
Address in
Decimal
D1 Bottom
on
off
off
off
33
D2
off
on
off
off
34
D3
on
on
off
off
35
D4 Top
off
off
on
off
36
2.5
Storage
It is recommended that the unit be stored in its original sealed packaging. The unit should be
stored in a dry location where the termperature is stable, away from direct contact with rain,
snow, wind, sun or anything that may cause damage.