Comtech EF Data KP-10 - Manual (Page 33)

KP-10 External Keypad Revision 1
Operation MN/KP10.IOM
23
3.3.2 M ULTIPLE U NIT A DDRESSES
To communicate with each terminal via the RSU, the following format is used:
! <*/ASR_ (Meaning: RSU command - address 1)
In the previous example, the KP-10 is connected to an RSU. The global address
command was sent first, then AS was pressed to access the address for a specific terminal
before sending other commands.
In the following example, the address (2) of Terminal A follows “*”:
! <*2/FS_ (Meaning: Terminal A command - address 2)
Note: Always make sure the correct address of any terminal (other than address 1) follows “*”
in the command string.
A list of typical commands used with an RSU includes the following:
<add/ 'ASA_'
<add/ 'ASB_'
<add/ 'ASR_'
<add/ 'BR_'
<add/ 'PS_'
<add/ 'ULS_'
<add/ 'ULM_'
<add/ 'DLS_'
<add/ 'DLM_'
<add/ 'HWC_'
<add/ 'ROS_'
<add/ 'RFS_'
<add/ 'RSF_'
<add/ 'RMS_'
<add/ 'ET_'
<add/ 'POLL_'
<add/ 'LM_'