Comtech EF Data CMR-6000 Manual - Manual (Page 20)

Digicast Media Router S2 Receiver CMR-6000 Revision 1
Introduction MN-CMR6000-IOM
1–2
1.1 Standard Features
Based on an embedded architecture, utilizing a FreeScale MPC859 CPU and eCOS Operating System, the
CMR-6000 features:
• High Reliability
• DVB-S and DVB-S2 L-Band Input
• ASI Input at rates as high as 213 Mbps
• Ethernet Output rates as high as 83 Mbps (1,500 byte packets)
• ASI Output rates as high as 213 Mbps
• Support for Multicast and Unicast IP datagrams
• Supports the decapsulation of MPE
• MPE Section Packing and Non-Section Packing on a PID-by-PID basis
• Supports encapsulation of transport streams over IP
• Support for all valid PIDs in 8192 range
• Support for the configuration of 64 simultaneous PIDs
• MPEG-2 188/204-byte operation
• Support for 802.1Q VLAN Tags
• IGMP for Multicast Route Announcements
• Redundancy via the CMR-Redundancy Scheme
• Configurable Telnet and HTTP ports for security
• Color LEDs for status monitoring and rapid fault isolation
• Management (monitor, control and configuration):
ƒ
Web Interface
ƒ TFTP for field software/firmware upgrade
ƒ Terminal Interface
ƒ Telnet
ƒ SNMP V2 (Private and MIB II) Support
ƒ Vload
1.2 Performance
Item Value
Maximum Bits Per Second
(Maximum Packet Size 1,500 Bytes)
83 Mbps
Latency Less than 10 ms
Minimum Symbol Rate
DVB-S (2 Msps)
DVB-S2 (2 Msps)
Maximum Symbol Rate
DVB-S (45 Msps)
DVB-S2 (32 Msps)
Minimum Input Level -50 dBm
Maximum Input Level -25 dBm
ASI to ASI PCR Jitter <75nS